OP-37 RV-10 Wiring Harness
Step 1: Inventory the entire kit.
Step 2: Read completely through both section 5W of the RV-10 Construction Manual and these instructions before beginning the installation.
Step 3: Remove the F-1003A Instrument Panel. NOTE All snap bushing callouts will accommodate the harness as provided, including the three conductor strobe cable which in not a part of the kit, and most but not all have room for more wires. However, the builder is ultimately responsible fro the proper sizing of the snap bushings for his/her own application.
Step 4: Size the snap bushings by lying out the harness in the fuselage using OP-37 as a guide, Place the Harness in the fuselage using OP37-1 as a guide. Place the harness in the fwd fuselage and unwind it. As the spool of wires is unwound the branching will become more obvious Go slowly in order to avoid putting a kink in the wires as they are untangled from the rest of the spool.
